سوفت كلين للتايجر t22 مع الطريقة الصحيحة لذلك

[ابو حاتم-]

يجب اعداد اللودر المرفق مع الملف بنفس طريقة الشرح واتباع نفس الخطوات
Must let the GxDump.exe and Config on the same folder
Close the receiver and connect the uart cable


1: Open the Tool GxDump.exe
2:set up tool

Chip Setting

Port: select one port connect with uart cable
Baud:9600 or 115200
chip model:Gx6107
RAM Type:DDRAM
RAM Size:32MB
XTAL Freq:4MZ

ACT Setting
Act:Update
Base:0x0 1 0000 (it must be setted right)
Lenth:0x0 0 0000

Flash Setting
Type:Spi-Flash
Mode:AT26DF161

3:after finishing the second step, press AppFile button
and select one file that you want to clear flash

4:press open button and link button, then you can see some charactor "Begin Updating Now",">>>>>>>>>>" on the right side

5:open the receiver power, then if you can see some charactor
"send 2KB Bin File"...
Boot file receiver ok
send chip..
....
...
app file length = ?

"***************************** *****
****************************** *****"


6:then you can not close receiver and turn off the power until the tool display "Compelete"

7:after finishing, restart receiver

[ابو المؤيد]

الله يعطيك العافيه اخي ابو حاتم على كل جديد

[qazee_rawahna]

عملت هيك وما زبط

[rosepure2003]

goooooooood

[nor sat]

شكرا لك

[عزيز محمد]

مشششكور

[عزيز محمد]

كل الحب والشوق

[عزيز محمد]

مشكو يا عالي

[عزيز محمد]

مشكوررر

[khalid_sat]

thanxxxxxxxxxxxxxxxx