3 طرق جديدة لتوصيل عدة لواقط

**ghamdan** · 30-08-2010 10:25 AM

Connect more than LNBs in 3 diffrent ways ....
عن طريق التحكم بمفتاح 22Khz switch
Connect more than LNBs in 3 diffrent ways ....

In the below example port A (port 1) has a 22Khz switch with satellite 75 22Khz on and satellite 4 with 22Khz off. There you have it 5 satellites using a diseqc switch and a 22 Khz switch.

n your receiver you will see a selection in Antenna setup called 22KHz the default setting is always off. By connecting a 22 KHz switch to your setup you can get a fifth satellite by using one port on the diseqc connected to a port on the diseqc switch and that port is used twice on your receiver one time with 22KHz on and the other time with 22KHZ off.

Above is a 22Khz switch that has 2 diseqc switches connected to its output one diseqc switch port 1 through 4 is 22 KHz on and the other diseqc switch ports 1 through 4 is 22 Khz off. This switch by passes the diseqc switch command and is a special 22 KHz switch, in our products section under switches this is the switch that is described as a Bypass diseqc command 22Khz Switch.

Multi switches allow you to use a dual lnb or multiple dual LNB's to get more than 2 receivers connected to your LNB. Outdoor multi switches allow you to use each dual LNB to connect up to 4 receivers as shown below.

The above diagram is for 2 LNBs to 4 receivers you can also add another 2 LNBs following the above example and another 2 multi switches to get 4 satellites and 4 receivers.