STAGE 2.
GOTO back to Main Menu \ Setup \ Service Searching \ Positioner Satfinder
Go down to "Satfinder"
Press ok on Satfinder next picture
Using L/R keys select "Predefined or Manual transponder" as required
Go down to "Satellite" and use the L/R keys to select the Satellite to place at the above Storage postion
Press "OK"
When you have a lock exit this screen
GOTO back to Main Menu \ Setup \ Service Searching \ Positioner setup
Press ok on positioner setup next picture
Go up to "Tune"
Press the "Red Button"
Select the satellite that you had a lock on, change the transponder so it was the same as in the satfinder picture
Go down to "Positioner storage"
Go down to "Positioner storage"
Use L/R keys to set the postion number that is to be setup
Press the GREEN button to store that ********
After you have stored this position got back to satfind and change the satellite to the next one you want to view, when you have a lock on this satellite exit again and proceed with the satellite positioner again .
You will need to perform this for each position you intend to set up in line with what you did in stage 1
P.S. i had already put settings in so i did not have to scan any sats in.
المفضلات