Raed Saadeh
10-04-2009, 11:14 PM
Using Infinity Phoenix as reader in Debian
1 - Install libusb-0.1.12 first
ftp libusb-01.12.tar.gz and go there... and do
gzip -cd libusb-0.1.12.tar.gz | tar xvf -
cd libusb-0.1.12
./configure
make
make install
2- Install nftytool1-1
ftp nftytool1-1.tar.gz and go there ... and do
gzip -cd nftytool-1.1.tar.gz | tar xvf -
cd nftytool-1.1
./configure
make
cd /home/nftytool-1.1
3- To start Infinity USB phoenix in phoenix mode do:
Connect usb and COM with programmer and run
cd /home/nftytool-1.1
this will start in 3.58 Mhz
./nftytool -p phoenix -- -p phoenix -f 3.58 -e
or
this will start in 3.68 Mhz :
./nftytool -p phoenix -- -p phoenix -f 3.68 -e
or
this will start in 6 Mhz :
./nftytool -p phoenix -- -p phoenix -f 6.00 -e
use
SERIAL READER : /dev/ttyS0
for COM1 in CCcam.cfg
P.S if you get error like gcc not found or something like that during install (make command), you have to install C compilations and libraries required. This is different on Linux versions. But for Debian you can do 'apt-get install build-essential'.
All these commands can be copied and pasted in to putty by by right mouse click
Files needed available here:
These files are required in order to use the Infinity Phoenix Programmer as a card reader for CCcam/Newcs in a linux server.
1 - Install libusb-0.1.12 first
ftp libusb-01.12.tar.gz and go there... and do
gzip -cd libusb-0.1.12.tar.gz | tar xvf -
cd libusb-0.1.12
./configure
make
make install
2- Install nftytool1-1
ftp nftytool1-1.tar.gz and go there ... and do
gzip -cd nftytool-1.1.tar.gz | tar xvf -
cd nftytool-1.1
./configure
make
cd /home/nftytool-1.1
3- To start Infinity USB phoenix in phoenix mode do:
Connect usb and COM with programmer and run
cd /home/nftytool-1.1
this will start in 3.58 Mhz
./nftytool -p phoenix -- -p phoenix -f 3.58 -e
or
this will start in 3.68 Mhz :
./nftytool -p phoenix -- -p phoenix -f 3.68 -e
or
this will start in 6 Mhz :
./nftytool -p phoenix -- -p phoenix -f 6.00 -e
use
SERIAL READER : /dev/ttyS0
for COM1 in CCcam.cfg
P.S if you get error like gcc not found or something like that during install (make command), you have to install C compilations and libraries required. This is different on Linux versions. But for Debian you can do 'apt-get install build-essential'.
All these commands can be copied and pasted in to putty by by right mouse click
Files needed available here:
These files are required in order to use the Infinity Phoenix Programmer as a card reader for CCcam/Newcs in a linux server.